Guide · Suno hiss

How to remove hiss from a Suno song

The hiss is a steady layer of noise that sits under the whole track. You hear it most in quiet intros, breakdowns and fade-outs, and on headphones.

Why the hiss is there

AI music generators do not record sound. They predict it and then decode it into audio, and that process leaves a noise floor in the file. It is part of the audio, so no prompt wording removes it.

Making the track louder makes the hiss louder too. A limiter cannot tell music from noise, so noise has to be reduced before mastering, not after.

Reduce it yourself

  1. Download the WAV if your Suno plan offers it. MP3 compression adds artifacts of its own on top of the hiss.
  2. Find a second or two where only the hiss is audible, usually the very start or end, and use it as the noise profile in a spectral noise-reduction tool. Audacity and ReaPlugs ReaFIR both do this for free.
  3. Reduce by a small amount, around 3 to 6 dB. Listen to cymbals, breaths and reverb tails while you adjust.
  4. Tame what is left with a de-esser or dynamic EQ above roughly 6 kHz, so the top end is only turned down when it is harsh.
  5. Master last: tone, compression, then loudness.

The common mistake is using too much. Heavy noise reduction makes a track sound muffled and watery, which is worse than the hiss. A low-pass filter has the same problem: it removes the air along with the noise.

How Decodec handles it

Decodec learns the noise floor of each file on its own, so there is no profile to capture and no setting to guess. It reduces only what sits close to that floor, then controls the top end with a de-esser, and only then compresses and masters the track.

The aim is a master where the hiss is no longer noticeable and the music still sounds open. You get a 30-second preview of your own track before paying, and a 24-bit WAV when you do.

Questions

Can the hiss be removed completely?

Not without damaging the music. The realistic goal is to push the hiss below the level a listener notices while keeping cymbals, breaths and reverb intact.

Will regenerating the song fix it?

Sometimes a new generation comes out cleaner, but the noise floor is part of how the audio is produced, so most versions carry some hiss.

Does it work on MP3 downloads?

Yes, but the result is better from a WAV, because MP3 compression adds its own artifacts in the same high-frequency range.

Related guides

Hear it on your own track first.

Upload a WAV and listen to a free 30-second preview before you pay.

Upload a WAV